Product Reviews
" We installed our HydroRight DualFlush in about 15 minutes: 10 minutes reading plus 5 minutes for the install! It has been in operation for about 2 days now and it works great. It does exactly what it says it does. It is quite evident that we will save gallons of water every month with this device. Well worth it."
Andy (Santa Barbara, C.A.)
" Upon opening this product I immediately noticed how well made it seemed (of course time will tell)! The mechanism doesn't use a chain like the standard flush lever in most toilets, which slip off if you push them to hard or fast. Rather it has a solid feeling button and cable system, which I really liked. After some time installing and adjusting it (30 Minutes including reading the directions and testing it after) it worked well and you can see that it really will save water when you use the quick flush button! Of course, it doesn't change anything if you use the full flush, but this helps out no matter. Also it is much cheaper than replacing a toilet!""
Joel
" This product is everything that was stated in the advertisement. The installation was easy. I can see the savings in the amount of water being used with each flush. I'm glad i waited for it to be on the market instead of repairing mine the old way."
Berry (Columbus, Ohio)
" This product is exactly as it is described in the promotional literature.I took less than 10 minutes to install and adjust. I did however have to purchase a Hydro Clean fill valve to replace the old ballcock filler valve.As both products are made by the same company I would suggest they might consider selling them as a unit rather than separately.I am completely satisfied with both products and recommend them to anyone interested in using less water, saving money and helping out the enviroment."
Barry
"This is is a product that really works amd will save you a lot of water over time. The hardest thing is getting it to seal but before filling your tank remove the top of the unit and look dow to make sure you haven't pinched the gasket."
Marla (Lindon, Ut)
HYDRORIGHT
Dual Flush Converter (HYR 270)
|
If you have a Mansfiled toilet, you will also have to purchase a standard Douglas Style Flush Valve (as seen on the right).
|
The HydroRight will not fit in a toilet tank that is less than 10" (25 cm) tall. There is a 10" (25 cm) Minimum Clearance from the highest point of the flush valve opening to the inside of the tank lid.
There is also a 6" (15 cm) Minimum Water Height requirement from the highest point of the flush valve opening. In most cases, the water height can be raised.
|
The HydroRight only replaces a standard size flapper 2-2.5" (5-6 cm)
|
If the HydroRight is installed in a toilet with an old ballcock, the arm of the ballcock might get blocked. In some cases, the HydroRight can be turned to compensate. In other cases, purchasing a HydroClean may be required.
|
In some cases purchasing a HydroClean or similar fill valve may be required.
|

HydroRight™ Dual Flush Converter (HYR 270)
Where to Buy
HydroRight Dual Flush Convertor
Introduction Video
Description
The HydroRight quickly and easily converts your toilet into a water-saving dual flush toilet. Quick flush for liquids and paper. Full flush for solids.
The Right Flush Every Time!
- • Uses up to 70% LESS WATER with liquids and paper
- • Installs without tools in 5-10 minutes
- • Tank removal not required
- • Works with all standard flush valves
- • Eliminates flapper problems
- • Invented by a plumber
Installation is as easy as 1,2,3:
- • Remove old flapper and handle
- • Slide Dual Flush down overflow tube (inside your tank) and tighten
- • Replace handle with button and set Quick Flush amount